Getting ready to put a motor bracket for the dinghy motor on the stern rail next to the swim ladder. What size is the tubing? Is it 1" tubing? Or something else? Thanks!
Mike
—
Jackfish Girl, 1999, C36 MKII, Tall Rig, Wing Keel, In-mast furling, Monument Beach, Bourne, MA
Ours is 1 inch.
David S. Power
Two If By Sea #1687
Burnt Store Marina
Punta Gorda, FL
Agree with 1-inch. Almost all chromed tubing on small boats is the same size, and it would look really strange to you if it was anything different. BTW, this is also a common size for motorcycle and off-road vehicle tubing, so things like light or utility clamps marketed for those sports also fit your boat. It's much cheaper to buy a ORV light clamp on Amazon, than a specialty marine something from West Marine, even if it's the exact same thing.
John Parsons
"Water Music" 1999 Catalina 36 Mk II - Hull 1771
Tall Rig, Fin Keel
Bay City, MI, USA
Great! I found a used Edson stern rail dinghy motor bracket for a couple hundred bucks. Thanks again.
Mike
Jackfish Girl, 1999, C36 MKII, Tall Rig, Wing Keel, In-mast furling, Monument Beach, Bourne, MA